Moehlenhoff Alpha IP - Setting Date and Time; Offset Temperature; Selection of Temperature Display;Humidity

POL RUSFINDAN SWENORENG
22
Operating modes and configuration
ENG
6.1.6 Setting date and time
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol “ “ and confirm the selection by shortly pressing the setting wheel.
3. Set the year, month, day and time by turning/pressing the setting wheel (E) and
conform each.
6.1.7 Offset temperature
Since the temperature is measured at the room control unit Display, it may be warm-
er or cooler in another position on the room. This deviation is corrected using the
offset temperature (up to ±3.5 °C).
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol “ “ and confirm the selection by shortly pressing the set-
ting wheel.
3. Turn the setting wheel and confirm the desired offset (max. ±3.5 °C) by shortly
pressing the wheel.
6.1.8 Selection of temperature display/humidity
The display alternately shows the actual or the set temperature as well as the hu-
midity, as required.
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol “ “ and confirm the selection by shortly pressing the setting wheel.
• “ACT” for displaying the actual temperature or
• “SET” for displaying the set temperature or
• “ACtH” for displaying the actual temperature and the current humidity