Moeller DF5 series - Restoring the Default Settings; Country Version

02/02 AWB8230-1447GB
Restoring the Default Settings
3
Restoring the Default Settings
Initialization
Two different types of initialization are available:
• Clearing the fault history register
• Restoring the default parameter settings
To delete the fault history register or to restore the default
settings, proceed as follows:
X Make sure that PNU b85 holds the value.
X Under PNU b84 (initialization), enter 00 or 01.
X Press the ENTER key to save the value.
X On the keypad, press both arrow keys and the PRG key at the
same time and keep them pressed.
X While holding the arrow and PRG keys, briefly press the
OFF key.
X Keep the other three keys pressed for three further seconds until
the following flashing display appears: d00.
X Now release all keys again.
Initialization is now complete.
Country version
Here, you define the country-specific parameter set which will be
loaded during initialization (a PNU b84).
PNU Name Adjustable in
RUN mode
Value Function WE
b84 Initialization – 00 Clearing the fault history register 00
01 Restoring the default parameter settings
PNU Name Adjustable in
RUN mode
Value Function WE
b85 Country
version
– 00 Japan 01
01 Europe
02 USA
03 Reserved