Admin Manual
MWP1100A
37
- RFC 2327: Sends signal according to the RFC 2327 specification. The RTP point of SDP is set as 0.0.0.0.
- RFC 3264: The hold type according to the RFC3264 specification. The SDP attribute is set as Secondary.
- Xener-Ebblock: The hold type of Xener SSW.
♦ Transfer type : Transfers a call according to the rules below. Since the call transfer function also follows the
operation specification between the vendor and the phone, configuration by the user is supported for
compatibility with other equipment. Transfer-07 is used by default.
One of the types below can be selected, but in most cases, transfer-07 is used.
- transfer-02: tries call transfer without the REFER method during signaling.
- transfer-05: performs the normal transferring operation. The server ends the transfer call.
- transfer-07: performs the normal transferring operation. The phone ends all the calls.
♦ MWI Subscribe : operates according to the specification of Message Waiting Indicator (MWI). It can be set
so that incoming messages via the Subscribe method are alerted to the phone by the server, but whether
the sever supports this function must be checked beforehand.
♦ SMS Code : The SMS code specified by the network provider must be entered. (default : 0)
To Next Page
Loading...