Admin Manual
MWP1100A
50
Auto Provision
It is a feature that enables remote configuration of important settings through cfg files instead of WEB or phone
buttons. To use the auto setting, a TFTP and HTTP sever must be in operation so that the configuration file can
be downloaded. Basically, the cfg file named for the phone’s MAC address is referred to and configuration is
done accordingly.
Ex) If the phone’s MAC address 00:11:A9:67:6D:11 ,
-> ‘0011A9676D11.cfg’ is refered to in the TFTP and HTTP server.
▣ Auto Provision
There are the following three modes.
♦ HTTP : automatic upgrade via the Web server. The default file name must be set after setting the
corresponding HTTP address and the port number.
♦ HTTPS : automatic upgrade via the Web server. The default file name must be set after setting the
corresponding HTTP address and the port number.
♦ TFTP : Get IP from the DHCP server, and then connect to the the TFTP server and download the
configuration. The TFTP server address and port number (Default: UDP - 69) must be set.
To Next Page
Loading...