molex MX123 - Product Introduction

MX123 Connection System User Manual - AS-34566-001 3
The Molex MX123 Connection System is a sealed system consisting of a
header/controller, mating connectors, and terminals with the following
configuration options:
A. 80-Ckt ~ (80) 0.64mm terminals
B. 73-Ckt ~ (72) 0.64mm and (1) 2.8mm terminals
C. 56-Ckt ~ (56) 0.64mm terminals
D. 49-Ckt ~ (48) 0.64mm and (1) 2.8mm terminals
E. 18-Ckt ~ (16) 0.64mm and (2) 6.3mm terminals
F. 10-Ckt ~ (8) 2.8mm and (2) 6.3mm terminals
HIGHLIGHTS:
 This system has multiple keying options.
 Ground blade engages before signal pins contact.
 Connector is friendly to “blind-mate” conditions.
 Connector provides temporary retention to the header before the cam assist
lever arm is activated.
 Cam assist lever arm remains in pre-lock position until the harness
connector is in pre-lock position on the header/controller.
 CPA remains in pre-lock position until cam assist lever arm is locked closed.
 Available with molded-in grommet seal plugs for harness customization.
Section 1: Product Introduction