MX123 Connection System User Manual - AS-34566-001 69
Section 11 (Appendix B): Cleaning Instructions
STEP 1: While the ECM connection is secure, use a small squirt bottle to squirt
water liberally and directly onto the connector slides and around all
exposed surfaces, top and bottom, to loosen dirt, grit, and small
rocks. The area around the CPA and primary latch should also be
sprayed off. The more water used, the cleaner it will become. Do not
attempt to un-mate any connectors until Step 4.
Water stream paths
Repeat Step 1
until there is no
visual evidence
of dirt, grit, or
other debris.
To Next Page
Loading...
