Need help?Do you have a question about the Molnar 3585 and is the answer not in the manual?
Identifies the Molnar Four Post Hoist models 3585 & 4488 covered by this manual.
Outlines minimum requirements for electrical connection including circuit breakers and voltage.
Details for the 2.2kW 240V single-phase motor model CWC3640F.
Technical specifications for the Molnar JB 87 Jacking Beam.
Key features and benefits of the Molnar JB 87 Jacking Beam.
Manufacturer's statement on quality, instructions, and specifications.
Essential safety checks and precautions before operating the hoist, including SWL.
Guidelines for safe operation, vehicle positioning, and handling damaged equipment.
Requirements for authorized operators and vehicle loading procedures.
Step-by-step instructions for raising and lowering the hoist platform.
Specifies suitable working environment and regular maintenance for the hoist.
Guidance on setting up the hoist, including drive-on end and power pack location.
Details required concrete slab strength, reinforcement, and thickness.
Addresses floor slope, leveling methods, and foundation block requirements.
Steps for positioning platforms and transverse beams and initial wire rope installation.
Details on correctly routing wire ropes and checking cable layouts on pulleys.
Instructions for fitting safety rails, power pack, and limit switches.
Procedures for aligning posts, securing them, and tensioning wire ropes.
Adjusting rollers, limit switches, fitting ramps, and final operational checks.
Step-by-step guide for fitting the drip tray (44880DRPT).
Wiring diagram for three-phase motor connections.
Wiring diagram for 4-post single-phase hoist connections.
Illustration and explanation of the general layout of the locking mechanism.
Instructions for assembling Betabite hydraulic fittings and joints.
List of available replacement parts with part numbers and drawing references.
Common faults, their probable causes, and recommended remedies.
Daily, monthly, and yearly maintenance checks for the hoist.
Guidelines for lubrication, oil changing, and topping up hydraulic oil.
Procedures for installing, inspecting, and handling the drip tray and its contents.
A checklist for installers to verify before signing off on the installation.
Procedure for loading rails on wheel-free systems and load distribution.
Form for certifying the hoist check and operator instruction.
The Molnar Four Post Hoist, models 3585 and 4488, is a vehicle lifting device designed for examination, repair, and maintenance purposes. Manufactured by Molnar Engineering Pty. Ltd., these hoists are built with high-quality materials and workmanship, adhering to AS/NZS 3000 electrical standards and AS1418.9 for vehicle hoists.
The Molnar Four Post Hoist is designed to lift vehicles, providing access to their undersides for various service tasks. It operates using a hydraulic system and a series of wire ropes and locking mechanisms to ensure safe and stable lifting. The hoist features a drive-on platform design, with options for drive-through operation. Operation is always controlled from Post No. 1, where the power pack and electric motor are mounted. The system incorporates safety rails, limit switches, and a load-holding control handle to ensure secure operation.
General| Brand | Molnar |
|---|---|
| Model | 3585 |
| Category | Industrial Equipment |
| Language | English |
To Next Page