What causes the drain flow restrictor jammed sideways in the valve of Monarch Water Dispenser?
If the drain flow restrictor is jammed sideways in the valve of your Monarch Water Dispenser, it is caused by: * Wrong assembly direction. Change the direction of DLFC.
What causes corroded PCB and ribbon cable in Monarch Water Dispenser?
Corrosion on the PCB and ribbon cable in your Monarch Water Dispenser can be caused by: * Too long refill duration, leading to salt water entering the board of the PCB. Replace the PCB.
General| Brand | Monarch Water |
|---|---|
| Model | Mini Aqua HE CS100 HE |
| Category | Water Dispenser |
| Language | English |
Locate softener tank and brine tank near a drain. Ensure a clean, level surface. Follow local plumbing codes. Use 1½" minimum pipe for drain line. Limit flexible drain line to 2m.
Connect the transformer to a continuous electrical supply. Attach the flying lead from the transformer to the controller adaptor.
Run hard water, rinse test tube. Fill to 10ml, add 2 drops dark solution, mix. Water turns red if hardness is present. Add solution in 5-drop batches.
Wait for Time of Day display. Press Up for flashing Hours (24hr clock), use Up/Down to set. Confirm with @. Set flashing Minutes similarly.
Checks for bypass valve, salt level, injector/screen blockage, water flow, leaks, flow meter issues, or incorrect programming.
Checks electrical service, controller operation, valve motor, and programming.
Checks for no power or PCB failure.
Explains common error codes (ER0101-ER0105) and troubleshooting steps like power cycling or pressing Regen.
To Next Page
