9
Connecting the Power
Now that all of the signal cables are connected, it is now time to connect the power.
IMPORTANT: Please follow the following instructions in sequence.
1. Connect the mains lead to the ASB-2 (leaving the switch in the off position).
2. Connect to wall socket and where applicable turn on.
3. Turn the mains power switch on the side of the amp panel to the on position. The ASB-2 will power on
straight away. The standby button will illuminate white and the LED on the front will flash blue as it goes
through the initial start up process and then slowly flash blue until it is connected to a wireless network or the
input changed.
To Next Page
Loading...
Need help?
General
