The ASB-2 will only pass through the HDMI source
that was selected when it goes into standby mode.
For example, if it is put into standby mode when HDMI
1 (eg, set top box) is selected and you wish to watch
that, then the HDMI pass through will work and a
picture will be displayed. However, something that is
connected to HDMI 2 (eg, Blu Ray player), then it will
not be displayed on the TV.
Front LED Brightness
The intensity of the main LED can be adjusted if it is
too bright for your requirements.
There are three settings, bright (default), dim and off.
Dim will set it to 50% intensity.
If set to off, the only feedback will be via the button
LED’s and the On Screen Display.
Firmware Update
Here, you can see what version of firmware the ASB-2
is currently running and check to see if an update is
available, although the ASB-2 will automatically check
for an update every time it is connected to the internet.
You may be asked for the firmware version should
you contact Monitor Audio for any technical or set up
advice.
To check to see if the firmware is up to date, use the
arrow buttons on the remote to navigate to ‘Check for
Update’ and press the right arrow.
It will then check and inform you that either it is up
to date, or that there is an update available. If there
is an update available, it will go through the update
procedure on page 22.
Factory Reset
This resets all of the customisable settings within the
menu structure of the ASB-2 back to their original,
factory settings.
18
AUTO STANDBY TIME
HDMI PASS THROUGH
FRONT LED BRIGHTNESS
To Next Page
Loading...
Need help?
General
