TROUBLESHOOTING | 23
Problem Solution
No sound in USB mode • Make sure the USB drive is in FAT32 file format, and it’s no greater than 32GB;
No sound in HDMI ARC mode
• Make sure the input source is set to ARC; the LED will display 'Hd'.
• Make sure your TV or external device supports ARC function and connect the HDMI cable to
the ARC port of the TV or external device.
• In the TV or external device setting menu, turn on the ARC function and the CEC function.
• In the TV or external device setting menu, find the audio output settings and change the
audio output mode to 'PCM' mode (instead of Auto, RAW, etc.)
• Make sure both ends of the HDMI cable are fully plugged into the sockets.
• If your TV or external device is muted or no sound output, press the Mute button on your TV’s
remote control to unmute.
• If none of these solutions work, try changing the HDMI cable.
• For HDMI ARC< ensure that the TV and soundbar is connected by a 19 core HD ARC cable.
No sound in Optical mode
• Make sure the input source is set to the correct mode; the LED will display 'OP'.
• Increase the volume of the soundbar to make sure it’s not muted.
• For optical, make sure you remove the small caps on either end of the optical cable, and both
ends are fully plugged into the sockets.
• If none of these solutions work, try changing the optical cable.
No sound in BT mode
• Increase the volume of the soundbar to make sure it's not muted. Make sure Bluetooth is
connected successfully - if not connected, the LED will flash 'bt'; once connected, the LED
will display 'bt'.
• Make sure the external Bluetooth device is playing normally and its volume is turned up.
To Next Page
Loading...
