3.3 Unpacking the Components
If an installation was ordered, we recommend leaving the system packed until a service representative
arrives.
Inspect shipment upon receipt
Before unpacking the system, please note the condition of the
boxes, shock watch sensors and tilt watch sensors. The boxes
should be intact and strapped to the pallets. If there is any
visible damage or if the sensors have been tripped, contact an
authorized service representative immediately and do NOT
proceed with unpacking.
Retain equipment packaging for future use
We recommend saving the original equipment packaging (foam, box, and pallets). The packaging is
specially designed to support and stabilize the equipment and will required if the unit needs to be
transported in the future. Some components must be packed upright on a pallet to avoid damage.
3.3.1 Unpacking the Compressor
Locate the compressor pallet.
1. Cut the bands securing the box to the pallet.
2. Carefully remove the box surround the unit. Lift directly up and over the surrounding foam.
3. Remove the top piece of foam to locate the hoses. Remove the hoses and set aside.
a. If you ordered long or oversized hoses, they will be in a separate box.
4. Using two people, lift the compressor off the pallet and gently set it on the floor. Take care not
to tilt the compressor.
5. The compressor has casters for moving it. Remove the plastic wrap and roll the unit to its
desired location.
Step 2: Removing compressor
box
Step 3: Locating vacuum and
helium hoses
Step 4: Compressor on
floor
3.3.2 Unpacking the Cryostat
Locate the cryostat box.
To Next Page
Loading...