1. Remove the box wrap and cut the bands securing the box to the pallet. Carefully lift the box off
the pallet and set on a nearby surface.
2. Open the side of the box and slide out the cryostat and foam onto an adjacent surface.
3. Lift off the top piece of foam.
4. Reach under the unit and grasp the main structure below the baseplate and sample chamber.
Supporting the system at the front and back, carefully lift the system out of the foam and onto
the table, taking care not to tilt more than 45°. A second person can assist with this step.
5. Carefully remove the plastic wrap around the main body and sample chamber. Leave the
window covers in place.
6. Gently slide the unit to the desired location on the optical table.
Step 2: Sliding out the cryostat
Step 4: Support and lift the unit out of the
foam
Step 4: Alternate back support location
3.3.3 Unpacking the Control Units
Locate the control unit boxes.
1. Remove the box wrap and cut the bands securing the box to the pallet. Carefully lift the box off
the pallet and set on the floor or a nearby surface.
2. Open the top of the box and remove the top piece of foam.
3. Reach inside and grasp the underside of the unit. Lift the unit up and out of the box. Keeping
the unit in the same orientation, set onto an adjacent surface.
4. Carefully remove the plastic wrap around the enclosure.
5. Move the unit to the desired location.
To Next Page
Loading...