EasyManua.ls Logo

Monterey 288SS - Page 65

Monterey 288SS
276 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
65
MONTEREY
BOATS
Fuel System
-
sion control systems, follow this procedure:
The fuel cap is designed to be opened by
hand and does not require a key. Turn the
cap counterclockwise to remove it for fueling.
Make sure the nozzle is equipped with an
automatic shutoff valve. Then put the nozzle


entire fueling operation.
Fill the tank until the shutoff valve clicks and

Remove the nozzle.
Install the fuel cap and tighten until the cap
clicks, indicating that the cap is tight and the
system is sealed.
Fueling Boats with International Fuel
Systems
Boats sold in countries other than the United
-
tems or vapor emission control components. The
fuel tank is vented to the atmosphere through

process for boats equipped with international fuel
systems is somewhat different than for boats sold
in the United States.
NOTICE:
When the fuel tank is full, some fuel will
      


closely while fueling to prevent fuel from
spilling into the water.
      -
tional fuel systems, follow this procedure:
The fuel cap is designed to be opened by
hand and does not require a key. Turn the
cap counterclockwise to remove it for fueling.
• 

during the entire fueling operation.
Fill the tank slightly less than the rated capac-
ity to avoid spilling fuel out of the vent/ fuel

Remove the nozzle.
Install and tighten the fuel cap. Make sure
you don’t overtighten the fuel cap and damage
the O-ring seal.
WARNING

SURE YOU DO NOT SPILL ANY FUEL. IF A SMALL AMOUNT
       
TO REMOVE THE FUEL AND PROPERLY DISPOSE OF THE
CONTAMINATED CLOTH. IF FUEL IS SPILLED ON THE WATER,
EXERCISE EXTREME CAUTION. FUEL FLOATS ON THE
SURFACE OF THE WATER AND CAN IGNITE. IF FUEL IS SPILLED
INTO THE WATER, IMMEDIATELY EVACUATE THE AREA AND
NOTIFY THE MARINA AND THE PROPER OFFICIALS.
Preparing the Boat for Operation - All
Boats
Use the following procedure to prepare the
boat for operation when fuel operations are
complete:
• Open all hatches, windows and doors. Run
the blower for at least four minutes to
completely ventilate the boat.
Check the fuel compartment and below the
deck for fuel odors. If you smell fuel, do not
start the engine.
DANGER
     
OR ENGINE COMPARTMENT WHILE FUELING CAN EXPLODE!!




STARTING THE ENGINE.

Table of Contents

Related product manuals