82
MONTEREY
BOATS
Electrical System
CO Monitor
Supplies 12-volt electrical current to the carbon
monoxide detector in the cabin. This is a “push to
reset” breaker that is normally on, unless tripped
by an overload, when the House battery switch is
activated. It should be checked, and the power
indicator on the carbon monoxide detectors should
be lit whenever someone is occupying the cabin.
If the breaker has tripped, it indicates that there
is a problem with the carbon monoxide detector,
the breaker, or the wiring from the breaker panel
to the detector. Always determine the cause of
the problem and correct it before resetting the
breaker.
Port Ignition
Provides protection and power for the computer
memory for the port engine. This “push to reset”
breaker is always supplied current when the bat-
teries are connected.
Memory
Provides protection and continuous power for the
stereo and electronics memory. This “push to
reset” breaker is always supplied current when
the batteries are connected.
Emergency Pump
Provides protection and power for the automatic
engine compartment bilge. This “push to reset”
breaker is always supplied current when the bat-
teries are connected. Another breaker in the helm
breaker panel provides circuit protection for the
manual switch.
Sump Pump
Provides protection and power for the automatic
to reset” breaker is always supplied current when
the HOUSE battery switch is activated.
Stbd Ignition
Provides protection and power for the computer
memory for the starboard engine. This “push to
reset” breaker is always supplied current when
the batteries are connected.
Windlass Circuit Breaker
A heavy duty circuit breaker that provides protec-
tion and power for windlass relay. This breaker is
supplied current when the battery selector switch
is activated. If the circuit breaker is tripped by an
overload, a yellow lever will be exposed near the
center of the breaker. Reset the breaker by rais-
ing the lever until it locks in the vertical position.
Engine Main Breakers
The primary circuits for the engine is protected
by heavy duty, “push to reset” breakers on each
engine. They are supplied power whenever the
engine battery switches are on. Refer to the en-
gine owner’s manual for information on the loca-
tion and operation of the engine circuit breakers.
288SS/328SS Helm Accessory Breaker
Panel
The helm accessory circuit breaker is located in
the cockpit near helm. The following is a de-
scription of the accessories supplied power and
protected by the “push to reset” breakers in the
panel.
Electronics
Provides protection and electrical current to the
electronics circuit at the helm.
VHF
Provides protection and electrical current to the
circuit for the VHF radio at the helm.
Acc
Reserved for additional 12 volt equipment.
Spotlight
Provides protection and electrical current to the
electronics circuit at the helm.
288SS & 328SS Helm Accessory Breaker Panel
To Next Page
Loading...
