Montigo DXFS User Manual

 Check local codes and
read all instructions
prior to installation.
 Leave this manual with
the owner.
For Mobile /Manufac-
tured Home approved
models:
 DXFS
 DFSP
 DXFS-MH
 DFSP-MH
Gas Conver-
sion Instruc-
tions
This appliance may be installed as an OEM installation in a manufactured
(mobile) home and must be installed in accordance with the manufacturer's
instructions and the manufactured home construction and safety standard,
Title 24 CFR, Part 3280 or Standard for Installation in Mobile Homes, CAN /
CSA Z240 MH.
This appliance is only for use with the type(s) of gas indicated on the rating
plate. A conversion kit is supplied with the appliance.
Warning: If the information in these instructions is not followed
exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
 Do not store or use gasoline or other ammable vapors and liquids in the
vicinity of this or any other appliance.
 What To Do If You Smell Gas:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot rea
ch your gas supplier, call the re department.
 Installation and service must be performed by a qualified installer, service agency or
the gas supplier.

Montigo DXFS Specifications

General

Brand	Montigo
Model	DXFS
Category	Indoor Fireplace
Language	English

Summary

Gas Conversion Instructions

General Information

Approved Manufactured Home Models

Lists specific Montigo models approved for manufactured and mobile homes.

Parts List

Conversion

Before You Begin

Safety precautions and initial steps before starting the conversion process.

Front Burner Conversion

Step-by-step instructions for removing and replacing the front burner orifice.

Rear Burner Conversion

Instructions for removing and replacing the rear burner orifice.

Pilot Assembly Conversion

Instructions for replacing the pilot orifice and reassembling the pilot assembly.

Main Gas Control Regulator Screw

Checking the Gas Pressure

Procedure for checking and verifying inlet and manifold gas pressures.

Pilot Burner Adjustment

Steps to adjust the pilot screw for proper flame size.

Operating Instructions

Safety - Read Before Lighting

Crucial safety warnings and procedures before lighting the appliance.

Lighting Instructions

Step-by-step guide for lighting the pilot and the appliance.

Turning Off Gas

Instructions on how to safely turn off the gas supply to the appliance.