What to do if the main burner will not light on my Montigo H38DF?
If the main burner on your Montigo Indoor Fireplace fails to light, first check the wiring as shown in figure 33. Also, verify that the wall switch has a proper connection.
What to do if the pilot won’t ignite on my Montigo H38DF?
If the pilot on your Montigo Indoor Fireplace won’t ignite, disconnect the remote wires and attempt to light the pilot again. If the pilot works after disconnecting the remote wires, it indicates that the remote connections are faulty.
How to fix a noisy pilot flame on a Montigo Indoor Fireplace?
To fix a noisy pilot flame on your Montigo Indoor Fireplace, locate the pilot adjustment screw on the gas control valve. Decrease the flame by turning the adjustment screw clockwise.
What to do if the main burner won't light on my Montigo H38DF Indoor Fireplace?
If the main burner on your Montigo Indoor Fireplace isn't lighting, examine the wiring (see figure 30 in the manual) and ensure the wall switch has a proper connection.
What to do if the pilot won't ignite on my Montigo H38DF?
If the pilot light on your Montigo Indoor Fireplace isn't igniting, disconnect the remote wires and attempt to light the pilot again. If it works now, the remote connections are likely faulty.
Details warranty voiding conditions, installation requirements, and relevant codes for safe setup.
Step-by-step instructions for connecting the gas supply line to the fireplace.
Wiring diagram for the gas control and pilot assembly of the H38DF-I model.
Critical safety warnings and procedures for models with electronic ignition.
Emergency procedure for gas leaks, applicable to all models.
Step-by-step guide for lighting models with electronic ignition.
Instructions for turning off gas supply, consistent across models.
General maintenance guidelines, including annual inspections and gas pressure requirements.
Diagram of the gas control valve and guide for pilot burner adjustment.
Flow chart and chart for troubleshooting common fireplace issues.
Outlines the warranty period for different components of the gas appliance.
Diagrams and text explaining required clearances for vent terminations in various locations.
General| Fuel Type | Natural Gas or Propane |
|---|---|
| Glass Type | Ceramic Glass |
| Ignition System | Electronic Ignition |
| Burner Type | Linear Burner |
| Warranty | Limited Lifetime Warranty |
| Type | Direct Vent |
| Venting | Direct Vent |
| Finish Options | Black |
| Glass Viewing Area | 36" W x 20" H |
| Weight | 200 lbs |
To Next Page
