We recommend that you follow the guidance below
when selecting a suitable location to install your
Washer Dryer.
Install your washer Dryer in an area that will allow
the door to fully open.
Make sure your Washer Dryer is located close to
electrical and plumbing connections.
We recommend installing your Washer Dryer on a
concrete oor and if possible in the corner of the
room. This will provide the greatest stability.
Do not install your Washer Dryer on a soft surface
such as carpet or rug.
Do not install your Washer Dryer in an area where
the temperature may drop below freezing. If hoses
freeze they may split or burst.
There are four transportation safety screws located
on the rear of your Washer Dryer (as shown in
Figure 3). They are used to protect your Washer Dryer
from damage during transportation and must be
removed before rst use. Please keep them in a safe
place and re-t them if transporting your Washer Dyer
in the future.
To remove the transportation safety screws:
1
Using a suitable spanner, rotate each safety
screw anti-clockwise until loose, and remove
(see Figure 3(a)).
2
Pull out the remaining plastic sections of each
screw by hand (see Figure 3(b)).
3
Insert the blanking caps into the four holes.
Push the cap until the connectors click into place.
When tted correctly, the cap will be ush with
the machine.
To ret the transportation safety screws for
transportation:
1
Remove each of the four blanking caps.
2 Insert the plastic sections of the safety screws into
the four holes.
3
Position the safety screws into the plastic sections
inserted in step 2 and use a suitable spanner to
tighten until secure.
Setting Up Your Washer Dryer
Setting Up Your Washer Dryer
WARNING: Risk of injury. Your Washer
Dryer is heavy and we strongly
recommend that it is moved by a
minimum of two people.
Note: The dimensions of your Washer
Dryer are 85 x 60 x 60 cm. Make sure that
the installation area has sucient space to
accommodate your appliance.
Note: If you have to install your Washer
Dryer on a wooden oor, we recommend the
installation of a water resistant wooden base
with a minimum thickness of 30 mm. Ideally
the base should be bolted down and span
several joists.
CAUTION: Before operating your Washer
Dryer, the transportation safety screws must
be removed. Failure to do so may cause
damage to your machine and will invalidate
your guarantee.
Figure 3
a
b
To Next Page
Loading...
