Setting Up Your Washer Dryer
Your Washer Dryer is supported by four adjustable
feet. Adjust the feet as necessary to ensure that your
appliance is level and secure:
1
Turn the plastic locking nut anti-clockwise to
loosen (see Figure 4(a)).
2
Turn the feet clockwise to increase the height of
the Washer Dryer (see Figure 4(b)).
3
Turn the feet anti-clockwise to decrease the height
of the Washer Dryer (see Figure 4(b)).
4
Once the Washer Dryer is level, turn the plastic
locking nuts clockwise to tighten (see Figure 4(c)).
Your Washer Dryer must be connected to the cold
water supply only. This increases eciency as only
the minimum amount of water required to wash your
laundry is heated.
To connect your Washer Dryer to the cold water
supply:
1
Connect the angled end of the ll hose to the
cold water inlet at the rear of the Washer Dryer by
screwing clockwise until hand tight (see Figure 5).
2
Connect the straight end of the ll hose to a
19 mm (3/4”) cold water tap by screwing clockwise
until hand tight.
Setting Up Your Washer Dryer
Spin
Daily Fast
Gentle Dry
Cotton Dry
Quick Wash & Dry
Cotton Wash & Dry
Rapid 15'
Cotton
Cotton Eco
Eco 20°C
Synthetics
Wool
Curtain
Rinse
Allergy Safe
Display Functions
Start/PauseDelayDry levelSpinTemp
60' 60 C
o
Note: If your previous machine had a hot
water connection, we recommend that you
check the hot tap on your water supply is
closed to prevent leakage.
Note: Make sure that the ll hose is not
trapped, kinked or cross-threaded.
Figure 4
Figure 5
a
b
c
To Next Page
Loading...
