29
PATCHBAY OVERVIEW (Continued)
RUN / STOP (GATE INPUT)
This input allows an external voltage to start and stop the DFAM Sequencer. When
a +5V signal is applied to this input, the Sequencer will play from its current pattern
location for the duration that the voltage is applied. When a 0V signal is applied to
this input, the Sequencer will stop at its current pattern location.
INPUT
0V to +5V Gate (+10V tolerant)
NOTE: An external Clock Signal applied here will advance the steps of the pattern in the same way
repeatedly pressing the RUN/STOP button does, but the Internal Clock is NOT synchronized.
ADV / CLOCK (SEQUENCER STEP ADVANCE / CLOCK INPUT)
This input allows the DFAM to be synchronized to an external clock source
such as another DFAM or a Mother-32. When the input of a clock’s rising edge
is detected, the Sequencer pattern is advanced by one step. In this mode, the
TEMPO knob is ignored.
INPUT
0V to +5V Clock Signal (+10V tolerant)
NOTE: Slowly changing signals may be ignored. An example of this would be an Accent assigned
to the Assignable output jack on the Mother-32.
TRIGGER (TRIGGER OUTPUT)
This output provides a pulse derived from the Sequencer Clock that can be
used as a clock source for synchronizing to other instruments, or as a Trigger
signal. Each time a new note is played via the sequencer, a +5V Trigger signal is
output both to DFAMs Envelope Generators and to the TRIGGER output jack.
OUTPUT
0V to +5V pulse (roughly 1ms in width)
VELOCITY (SEQUENCER VELOCITY CONTROL VOLTAGE OUTPUT)
This output provides a voltage that varies based on the VELOCITY setting of
the currently selected Sequencer step.
OUTPUT
0V to +5V Control Voltage
PITCH (SEQUENCER PITCH CONTROL VOLTAGE OUTPUT)
This output provides a voltage that varies based on the Pitch setting of the
currently selected Sequencer step.
OUTPUT
-5V to +5V Control Voltage
To Next Page
Loading...
