45
GLOBAL MENU PARAMETERS (CONTINUED)
POT MODE (GLOBAL MENU 1.4)
When changing presets, the physical positions of the panel knobs will not match the values saved in a
preset. POT MODE allows you to specify how a knob responds when you make changes to its position.
ABS: In absolute mode (default) the value of a parameter jumps to the knob’s current position as soon
as you begin turning it.
THRU: In pass through mode turning a knob has no effect until it reaches its preset value and then
takes effect.
RLT V: In relative mode turning a knob up or down slightly causes a minor change in value, while
turning it further causes an increasingly greater change in value. This allows the value to “catch up”
with the knob’s position and prevents any sudden jumps in sound.
NOTE: Relative and pass through modes are recommended for live performance, while absolute mode is
recommended for creating new sounds.
LOCAL CONTROL (GLOBAL MENU 1.5)
Highlight LOCAL CONTROL >> and press the CURSOR button to enter the LOCAL CONTROL sub menu.
Sometimes it’s useful to disable the keyboard and/or other physical controllers on the Sub 37 when
using it as a MIDI controller or when recording tracks into a DAW.
ALL
When ON, all of the Sub 37 controls, features, and functions send MIDI data to the Sub 37
as well as the specified MIDI OUTs. When OFF, no physical controls, features, or functions have
any impact on the Sub 37, but all MIDI data is still transmitted to the specified MIDI outputs.
KEYS
When ON, the Sub 37 keyboard sends MIDI data both to the internal sound engine as well as
the specified MIDI OUTs. When OFF, the keyboard data is not transmitted internally meaning it has no
effect on the Sub 37, but keyboard MIDI data is still transmitted to the specified MIDI outputs.
WHEELS
When ON, the Sub 37 PITCH bend and MODULATION wheels send MIDI data both to the internal
sound engine as well as the specified MIDI OUTs. When OFF, the pitch bend and modulation
data is not transmitted internally meaning it has no effect on the Sub 37, but their MIDI data is
still transmitted to the specified MIDI outputs.
PANEL
When ON, all of the Sub 37 knobs and buttons send MIDI data to the Sub 37 as well as the
specified MIDI OUTs. When OFF, no physical knobs or panel buttons have any impact on the
Sub 37, but their MIDI data is still transmitted to the specified MIDI outputs.
CV MAPPING (GLOBAL MENU 2.1)
The CV MAPPING submenu allows you to map the external PITCH CV, VOLUME CV and KB GATE
inputs to various parameters and functions. The CV mapping of PITCH CV and VOLUME CV to a
desired parameter allows you to connect a continuous controller pedal (with a 1/4” TRS plug) to
one of the CV inputs and then directly control the mapped parameter. The KB GATE input is similar
but uses a 1/4” TS footswitch and typically controls switch-based parameters.
PITCH
Maps an external PITCH CV controller to virtually any Sub 37 sound parameter, as well as three
special functions, SQMODAMT, RTCHT CT, and ST1 RESET.
SQMODAMT: Sequence Mod Amount scales the SEQ MOD values stored in each step
of the Sequence.
To Next Page
Loading...
Need help?
General
