51
CONTROLLERS MENU (CONTINUED)
PGM DST
This parameter allows you to specify the MOD’s sixth modulation destination from the
default of EG TIME to:
FILT RES: Filter Resonance Amount FILT DRV: Filter Multidrive Amount
FILT SLP: Filter poles slope (-6, -12, -18, -24) F EG AMT: Filter Envelope Generator Amount
F KB AMT: Filter Keyboard Tracking Amount OSC1 LEV: Oscillator 1 Level
SUB LEV: Sub Oscillator Level OSC2 LEV: Oscillator 2 Level
EXFB LEV: External Input /Feedback Level OSC1 ON: Oscillator 1 ON/OFF Control
SUB ON: Sub Oscillator ON/OFF Control OSC2 ON: Oscillator 2 ON/OFF Control
NOISE ON: Noise Generator ON/OFF Control EXFB ON: External Input/Feedback ON/OFF
ARP RATE: Arpeggiator Rate ARP CLKDV: Arpeggiator Clock Divisions
ARP RNGE: Arpeggiator Range ARP BKFD: Arpeggiator Backwards/Forwards
ARP BFMD: Arpeggiator Back/Forth Ends ARP INV: Arpeggiator Invert
ARP GLEN: Arpeggiator Gate Length ARP RUN: Arpeggiator Run/Stop
GLD TIME: Glide Time GLD OSC: Glide Oscillator Assignment
GLD TYPE: Glide Type (LCR, LCT, or EXP) GLD GATE: Glide Gated Control ON/OFF
GLD LGTO: Glide Legato GLD ON: Glide ON/OFF
LFO1CKDV: LFO 1 Clock Divisions (When Synced) LFO1RNGE: LFO 1 Range (LOW, MED, HIGH)
LFO1SYNC: LFO 1 Arp Sync ON/OFF LFO1KBRS: LFO 1 Keyboard Reset ON/OFF
LFO1KBTRK: LFO 1 Keyboard Tracking Amount MOD1PAMT: Mod Bus 1 Pitch Amount
MOD1FAMT: Mod Bus 1 Filter Amount MOD1PGMA: Mod Bus 1 Programmable
MOD1PDST: Mod Bus 1 Programmable Destination Amount
Destination LFO2CKDV: LFO 2 Clock Divisions (When Synced)
LFO2RNGE: LFO 2 Range (LOW, MED, HIGH) LFO2SYNC: LFO 2 Arp Sync ON/OFF
LFO2KRST: LFO 2 Keyboard Reset ON/OFF LFO2KTRK: LFO 2 Keyboard Tracking Amount
MOD2PAMT: Mod Bus 2 Pitch Amount MOD2FAMT: Mod Bus 2 Filter Amount
MOD2PGMA: Mod Bus 2 Programmable MOD2PDST: Mod Bus 2 Programmable
Destination Amount Destination
OSC1 OCT: Oscillator 1 Octave (16’, 8’, 4’, 2’) OSC2 SYNC: Oscillator 2 Hard Sync ON/OFF
OSCKBRST: Oscillators Keyboard Reset OSC2 OCT: Oscillator 2 Octave (16’, 8’, 4’, 2’)
OSC2KCTL: Oscillator 2 Keyboard Control for OSC 2 DUO: Oscillator 2 Duophonic mode ON/OFF
Duo Mode (DRONE, LOW NOTE, HIGH NOTE) OSC2FREQ: Oscillator 2 Frequency Offset
OSC2BEAT: Oscillator 2 Beat Frequency Offset F EG ATK: Filter Envelope Generator Attack
F EG DCY: Filter Envelope Generator Decay F EG SUS: Filter Envelope Generator Sustain
F EG REL: Filter Envelope Generator Release F EG DLY: Filter Envelope Generator Delay
F EG HLD: Filter Envelope Generator Hold FEG VAMT: Filter Envelope Generator Velocity
FEG KTRK: Filter Envelope Generator FEG MTRG: Filter Envelope Generator Multi-
Keyboard Tracking Amount trigger ON/OFF
FEG RST: Filter Envelope Generator Reset FEG SYNC: Filter Envelope Generator Sync to
ON/OFF Arpeggiator Clock
FEG LOOP: Filter Envelope Generator Loop FEG LTCH: Filter Envelope Generator Latch
ON/OFF ON/OFF
A EG ATK: Amplitude Envelope Generator Attack A EG DCY: Amplitude Envelope Generator Decay
A EG SUS: Amplitude Envelope Generator Sustain A EG REL: Amplitude Envelope Generator Release
A EG HLD: Amplitude Envelope Generator Hold AEG VAMT: Amplitude Envelope Generator Velocity
AEG KTRK: Amplitude Envelope Generator AEG MTRG: Amplitude Envelope Generator
Keyboard Tracking Amount Multi-trigger ON/OFF
AEG RST: Amplitude Envelope Generator AEG SYNC: Amplitude Envelope Generator
Reset ON/OFF Sync to Arpeggiator Clock
AEG LOOP: Amplitude Envelope Generator AEG LTCH: Amplitude Envelope Generator
Loop ON/OFF Latch ON (always ON) /OFF
OUT VOL: Master Volume Level BEND UP: Pitch Bend Up Max Amount
BEND DOWN: Pitch Bend Down Max Amount ARP SWING: Arpeggiator Swing Amount
LFO1SWNG: LFO 1 Swing Amount LFO2SWNG: LFO 2 Swing Amount
SQMODAMT: Seq Mod Amount To Destination RTCHT CT: Ratchet Count (1 - 8)
To Next Page
Loading...
Need help?
General
