moon 860A - Specifications; Configuration and Power; Performance Metrics; Electrical and Physical Data

MOON 860A Dual-Mono Power Amplifier
Specifications
Configuration ......................................................... Dual Mono
Power Supply Transformers .................................... 2 x 0.5kVA
Power Supply Capacitance ...................................... 121,200µF
Class Of Operation ................................................. A/AB
Design .................................................................... Fully Balanced Differential to output stage
Input Impedance ................................................... 47,500Ω
Input Sensitivity ..................................................... 1100mV
Output Device Type ................................................ Bipolars - 12 per channel
Output Power at 8Ω ............................................... 200 Watts per channel
Output Power at 4Ω .............................................. 400 Watts per channel
Output Power – Bridged Mono at 8Ω ....................... 800 Watts
Frequency Response .............................................. 10Hz - 200kHz +0/-3dB
Output Impedance ................................................. 0.01Ω
Damping Factor (static) ......................................... 800
Gain ...................................................................... 31dB
Signal-to-noise Ratio .............................................. > 106dB @ full power
Maximum Output Voltage ....................................... 40 Volts
Slew Rate .............................................................. 42V/µs
Maximum Current – Peak ........................................ 48 amperes
Maximum Current – Continuous .............................. 22 amperes
Crosstalk @ 1kHz ................................................... -105dB
Intermodulation Distortion ...................................... Unmeasureable
THD (20Hz - 20kHz @ 1 watt) ................................ < 0.015 %
THD (20Hz - 20kHz @ 200 watts) .......................... < 0.04 %
Power Consumption @ idle ..................................... 55 Watts
AC Power Requirements ......................................... 120V / 60Hz or 240V / 50Hz
Shipping Weight ..................................................... 90 lbs / 40 Kgs
Dimensions (W x H x D, inches) .............................. 18.75 x 7.5 x 17.5
Balanced Pin Assignment: Pin 1................................ Ground
Pin 2................................ Positive
Pin 3 .............................. Negative
12 Volt Trigger: Logic............................... Direct (0V off, 12V on)
Jack................................. 3.5mm microphone jack
Input Impedance.............. 1kΩ
Current Consumption........ 12mA
NOTE: In the event that you require either the RS-232 codes for your MOON 860A or would like to
operate this amplifier in a bridged mono configuration, please contact Simaudio Ltd. directly
by either email (service@simaudio.com) or toll-free telephone (877-980-2400).
Fuse Replacement: For the 120V version use a 8A fast blow (3AG size).
For the 230V version use a 4A fast blow (3AG size).
____________________________________________________________________________________
Specifications 11