Need help?Do you have a question about the moon 220i and is the answer not in the manual?
Amplifier Specifications| configuration | Stereo |
|---|---|
| class of operation | Class A/B |
| output power at 8Ω | 40 Watts per channel |
| output power at 4Ω | 80 Watts per channel |
| output impedance | 0.04Ω |
| damping factor | > 200 |
| signal-to-noise ratio | 101dB @ full power |
| maximum output voltage | 20 Volts |
| slew rate | 20V/µs |
| maximum current output | 14 amperes |
| frequency response | 10Hz - 100kHz +0/-3dB |
| crosstalk at 1kHz | -78dB |
| intermodulation distortion | < 0.07% |
| THD (20Hz - 20kHz @ 1 watt) | < 0.015% |
| THD (20Hz - 20kHz @ 40 watts) | < 0.03% |
Inputs and Outputs| single-ended inputs | 5 (RCA) |
|---|---|
| mini-jack input | 1 (1/8”) |
| preamplifier output | 1 (RCA) |
| headphone output | 1 ( 1/4” Stereo TRS) |
Power and Dimensions| AC power requirements | 120V / 60Hz or 240V / 50Hz |
|---|---|
| shipping weight | 20 lbs / 8 Kgs |
| dimensions (W x H x D) | 16.9 x 3.5 x 14.5 inches |
Warning to reduce fire/shock risk by avoiding rain or moisture exposure.
Caution against opening unit to prevent electric shock risk.
No user-serviceable parts inside; refer all servicing to qualified personnel.
Instructions for removing the amplifier from its box and performing a physical inspection.
Advice on positioning the amplifier for optimal performance and ventilation.
Steps for connecting the amplifier to the AC power source for optimal sonic performance.
Procedure for powering on the integrated amplifier for initial use.
Recommended sequence for powering amplifier and source components to avoid audio noise.
To Next Page
