Pre Start Inspection and Operation
3.28
d. While holding both of the control levers in the reverse position and the attachment
operating, rotate the CRAWL control lever counter-clockwise until you set the proper
travel speed for the attachment being used.
NOTE: Rotating the crawl control lever counter-clockwise increases the travel
speed from very slow to full operating speed. The faster the machine travels, the
less hydraulic power will be directed to the attachment. The slower the machine
travels, more hydraulic power will be directed to the hydraulic attachment.
e. When the crawl travel speed has been set properly, steering and direction control can be
adjusted by using either or both of the travel control levers.
When using CRAWL VALVE control and the travel controls together with an
attachment activated, DO NOT release the Attachment Activation Lever until the travel
controls are in the NEUTRAL position.
3. To return to full operating speed, release both travel control levers and rotate the
CRAWL control lever counter-clockwise past the highest speed setting into the
“detent” OFF position. Full speed range will be returned to the main travel control
levers.
To Next Page
Loading...
