Morbark BOXER 532DX - Daily Maintenance Procedures

Routine Service and Maintenance
4.2
Daily Maintenance Procedures
Do the following procedures daily or every 10 operating hours:
1. Check condition of all warning and instructional decals. Before operating the
machine, replace any missing or damaged decals.
NOTE: Make sure to read and understand all WARNING and SAFETY decals
before operating the machine.
• Allow engine to cool before lling fuel tanks.
• Do not overll because fuel could spill onto hot engine parts and ignite or
explode.
• Make sure engine is turned off.
2. Check engine fuel and ll as needed:
a. The Boxer has a saddle tank (Item 1, Figure 4–1), on each side of the machine.
Figure 4-1 Fuel Level Check
b. Each of the tanks has a fuel gauge located in the ller cap (Item 2, Figure 4-1). Remove
cap and visually inspect fuel level to make sure that the indicator is showing the proper
fuel leve. Make sure that each tank has been lled on a dail basis.
c. Carefully pour gas into the tank, not exceeding the max ll indication shown by the
gauge in the fuel cap.
CAUTION
1
1
E
F
2