GENERAL WARNINGS AND SAFETY
The User, Installation and Maintenance Manual is an integral part
of the product and must therefore be carefully stored and always
accompany the appliance; in case of loss or damage, download
another copy from www.morcoproducts.co.uk.
Use of the appliance requires strict adherence to certain fundamental
safety rules:
In parts of the manual the following symbols are used:
WARNING = for actions that require caution and adequate preparation
PROHIBITED = for actions that MUST NOT be performed
Failure to comply with the recommendations of this manual
and failure to adhere to the instructions included therein by
installers and by the user will invalidate any future warranty
claim.
The safety devices must not be adjusted and in the event
of failure must be replaced with original manufacturer parts.
If the water heater is to be left unattended for any period,
shut off the gas supply. Where the risk of freezing is
anticipated, refer to the winterisation section on page 17.
In case of failure and/or malfunction of the appliance, switch
it off and do not attempt any kind of repair. Contact a Gas
Safe Engineer or other qualified personnel.
At the end of its life span the product must not be disposed
of as solid urban waste but must be removed to a recycling
centre.
Where the smell of gas is perceived, refrain from using any
electrical switches, telephones or any other object that
could cause sparks. Ventilate the room by opening doors
and windows and turn off the gas supply.
Do not place objects on the appliance.
Do not leave containers of flammable substances in the
room where the appliance is installed.
The use of this appliance by children or inexperienced
persons is not recommended.
The appliance must be used as intended by the manufac-
turer. Contractual and non-contractual liability is excluded
for damage to persons, animals or property, due to installa-
tion, adjustment and maintenance errors or improper use.
Do not use the appliance for purposes other than those for
which it was intended.
Installation of the appliance and subsequent maintenance
must be performed by a Gas Safe Engineer or other
qualified personnel in compliance with the legislation in
force.
The casing can reach high temperatures in the burner
area, with the risk of burns in the event of contact.
Any attempt to carry out a repair in case of failure and/or
malfunction of the appliance should be by a Gas Safe
Engineer.
Maintenance is recommended on an annual basis. Use a
Gas Safe Engineer to carry this out.
Do not clean the appliance and/or its parts with flammable
substances (.g. petrol, alcohols, oil, etc.).
To Next Page
Loading...
