MORTEX PRODUCTS INC 501 TERMINAL RD FORT WORTH, TX 76106 Page 10
SERVICE AND MAINTENANCE MANUAL
THE HOMEOWNERS AND FURNACE USERS MUST STOP HERE!
This section has been designed to assist a qualied service
agency in performing service and maintenance on this furnace.
Homeowners or furnace users must never attempt to perform
maintenance or service on this furnace, especially when furnace
components must be replaced or adjusted.
The furnace manufacturer is not responsible for damage
to the furnace or furnace malfunctions due to improper
parts changes, improper maintenance, improper furnace
adjustments, or improper modications made by the
homeowner or furnace user.
The furnace manufacturer is not responsible for damages,
repairs, or injury if the homeowner or furnace user uses
this section of the instructions in an attempt to perform
maintenance or repairs to the furnace. This practice is very
dangerous and may result in property damage, personal
injury, or death due to a re, explosion, or electrical shock.
If the homeowner or the furnace user attempts to perform
any maintenance or repairs to this furnace, the warranty
will be voided and the homeowner will be responsible for
all repair costs and/or damages.
Improper adjustment, service or maintenance may create a
condition where the operation of the product could cause
property damage, personal injury, or death.
FIRE OR ELECTRICAL HAZARD
Failure to follow the safety warnings in this manual or on
labels axed to the furnace may result in a re or electrical
hazard which may cause property damage, serious injury,
or death.
This is a safety alert symbol. When this symbol is seen on
labels or in manuals, be alert to the potential for personal injury.
Understand and pay particular attention to the signal words
DANGER, WARNING, or CAUTION.
DANGER: Indicates an imminently hazardous situation, which if
not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation, which if
not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation, which if
not avoided, may result in minor or moderate injury. It is also
used to alert against unsafe practices and hazards involving
property damage.
The following safety rules must be followed when servicing
this furnace.
This product must be serviced and maintained as specied
in these instructions and to any applicable local, state,
and national codes including, but not limited to building,
electrical, and mechanical codes.
SAFETY REQUIREMENTS
1. This gas red furnace is powered by a 115 volt, 60 Hz electrical
supply circuit. Check each electrical circuit with a meter to
be sure the power has been disconnected before servicing the
furnace.
2. Insulating materials may be combustible. This furnace must be
kept free and clear of insulating materials.
3. Follow the instructions in Section 3: Startup and Shutdown
Section of the User Information Manual to properly start or
shut the furnace o.
4. Make sure all moving parts have come to a complete stop
before the furnace door is removed to perform service or
maintenance. Moving parts can cause serious injury or death if
clothing or body parts get caught in the moving parts.
SECTION 1: SAFETY
ELECTRICAL SHOCK AND FIRE HAZARD
• Failure to follow the safety warnings in the manual or
on the labels axed to the furnace may result in property
damage, serious injury, or death.
• Improper servicing could result in property damage,
serious injury, or death.
• Placing jumper wires between the RED and WHITE
thermostat wires at the furnace in order to bypass the
thermostat and energize the heater is an extremely
dangerous practice that can result in damage to the
thermostat, property damage, serious injury, or death.
• Before servicing, disconnect all electrical power to the
furnace.
• When servicing controls, label all wires prior to
disconnecting to aid in proper reconnection of wires.
• Verify proper operation after servicing by turning the
thermostat above the room temperature for a brief period
of time to ensure future operation.
To Next Page
Loading...
