MORTEX PRODUCTS INC 501 TERMINAL RD FORT WORTH, TX 76106 Page 4
Do no wet electronic components or wire connections
during the gas leak test. Wetting electronic components
may damage circuitry and wire connections and can cause
a hazardous situation.
Dry moisture from all leads and terminals if wetting does
occur.
Wait at least 12 hours for the electronic components and
wire connections to fully dry before energizing the furnace.
This furnace area must never be used as a broom closet, for
any other storage purposes or allow the furnace to come in
contact with the following substances.
1. Spray or aerosol cans, rags, brooms, dust mops, vacuum
cleaners, or other cleaning tools.
2. Soap powders, bleaches, waxes, other cleaning
compounds, plastic items or containers
3. Gasoline, kerosene, cigarette lighter uid, dry cleaning
uids, or other volatile uids.
4. Paper bags, boxes, or other paper products.
FIRE OR ELECTRICAL HAZARD
Servicing the furnace can be hazardous due to exposure
to electrical components. Only trained and qualied
personnel are allowed to service or repair this furnace. The
homeowner or user must never attempt to service or repair
this furnace.
The homeowner or user may perform only basic
maintenance functions such as cleaning of exterior
surfaces and replacing the air lters.
Observe all precautions in the manuals and on the
attached labels when performing maintenance on this
furnace.
Figure 1: Component Locations
Figure 2: Burner Flame
To Next Page
Loading...
