62 Chapter 4 Troubleshooting and FAQs Troubleshooting
The CL900 responds to my finger but not my pen
• The tablet may be configured to ignore pen input. To check, open Motion Dashboard
then tap Pen & Tablet. Tap Touch Settings and tap the Digitizer Options tab. Set Input
mode to the recognize both touch and pen.
The CL900 tablet is too sensitive to touch
• Consider changing a touch setting so that you have to double-tap the display to enable
touch. Open
Motion Dashboard then tap Pen & Tablet. Tap Touch Settings and then
Auto mode.
The touch pointer jumps around the display and the display flickers
• In some cases, the tablet’s touch system gets out of sync. To fix it, you can re-tune it.
Open
Motion Dashboard, then tap Pen & Tablet, tap Touch Settings, tap Touch Tuning,
then Start. A calibration program begins. Do not touch the display until the program has
finished.
Calibrate does not work
• The Tablet PC Settings Display tab has a Calibrate option but it does not apply to the
CL900. Instead, if touch input does not behave as expected, you can re-tune touch.Open
Motion Dashboard, then tap Pen & Tablet, tap Touch Settings, tap Touch Tuning, then
Start. A calibration program begins. Do not touch the display until the program has
finished.
Ports and connectors problems
The system does not recognize the USB 2.0 device
• Windows 7 may take a short time to recognize the USB device. Wait a few moments to
see if Windows recognizes the device.
• The device may not be connected properly. Check the connection and ensure it is
inserted properly into the USB port.
• The correct driver might not be included with Windows 7. Check the manufacturer’s
website for a current driver.
The CL900 is in its dock, but the system does not recognize any accessory devices,
such as the external disk drive or monitor
• The CL900 may not be fully seated in the dock. Remove it from the dock and then
replace it.
Network problems
The wireless adapter keeps connecting even when I do not want it to
• Disable the desired wireless adapter from the Motion Dashboard. Open Motion
Dashboard, tap Wireless and clear the check box next to the wireless adapter that you
want to disable.
To Next Page
Loading...
Need help?
General
