WIRING AND BATTERY INFORMATION
eng 9
Wiring and Battery Information
!
WARNING
An operating or charging battery produces gas that can ignite and
explode, spraying out sulfuric acid, which can cause severe burns.
Ventilate the area around the battery and wear protective equipment
when handling or servicing batteries.
!
WARNING
Performing service or maintenance without first disconnecting the
battery can cause product damage, personal injury, or death due to
fire, explosion, electrical shock, or unexpected motor starting.
Always disconnect the battery cables from the battery before
maintaining, servicing, installing, or removing motor components.
Standard Practices and Procedures
When installing or removing this trolling motor, follow these
guidelines:
• Disconnect the trolling motor from the trolling motor battery.
• Do not use the main engine battery to power the trolling motor.
Battery Recommendations
• Use a 12 volt, deep cycle marine battery.
• Install a 50 amp manual reset circuit breaker in line with the
trolling motor positive leads within 180 cm (72 in.) of the
batteries.
• If extending the existing wire beyond the standard battery cable,
use 13 mm (6 gauge) battery cables.
Recommended MotorGuide Accessory Description
Part Number
6 gauge battery cable and terminals with 50 amp manual reset
breaker
MM309922T
50 amp manual reset breaker MM5870
To Next Page
Loading...
Need help?
General
