Motorola 2.1 - Part II - Power Cable with Flying Leads; Part III - Power Connector and Cable Assembly Instructions; Figure 9-3 Feed Flying Lead Cable through Components; Figure 9-4 Attach Flying Lead Cable to the Plug

Appendix A:
Part II – Power Cable with Flying Leads
2. The initial Power Cable will have four wires, cut the Red Wire back, as it is not used.
Figure 9-3 Feed flying lead cable through components
NOTE: Be sure to cut the RED WIRE Back as it in not used
Part III – Power Connector and Cable Assembly Instructions
3. Place the Connector parts over the Power Cable as shown below.
Figure 9-4 Attach flying lead cable to the plug
9-11