Motorola 2.1 - Figure 9-21 Correct Position of the Cable Wires Attached to the Plug; Figure 9-22 Finished Plug

Appendix A:
7.
Spread out the three wires, so that the Blue wire is on the right side, the Brown wire is on the left
hand side, and the Green wire is in the center.
8. Attach the cable wires to the terminal plug in the following way:
Figure 9-21 Correct Position of the Cable Wires Attached to the Plug.
9.
Fold the plug back into a closed position and turn the plug to show the access screw. Tighten the
Access Screw on the plug to lock the plug assembly in place.
Figure 9-22 Finished Plug
A
ccess Screw
Insert the Green Wire into
the Ground lug and tighten.
Insert the Blue Wire into the
Neutral lug and tighten.
Insert the Green Wire into
the Ground lug and tighten.
9-19