S
Stanley RasmussenJul 31, 2025
What to do if Ethernet LEDs are not lit on my Motorola 2247-62-10NA - Netopia 2247-62 Wireless Router?
- LLarry BrownJul 31, 2025
If the Ethernet LEDs on your Motorola Gateway are not lit, ensure you're using the correct Ethernet cable (thicker than a standard telephone cable) and that it's securely plugged into both the Ethernet jack on your PC and the Ethernet port on the Gateway. If possible, test with another Ethernet cable. Also, verify that Ethernet drivers are installed on your PC, the TCP/IP Properties are set to obtain an IP address via DHCP, the PC has obtained an address in the 192.168.1.x range, and the PC is configured to access the Internet over a LAN. Disable any unused network devices.