EasyManua.ls Logo

Motorola 700 Series - Page 152

Motorola 700 Series
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index
IN-2
I
N
D
E
X
commands
Configure Board Information Block
(CNFG) A-1
Set Environment (ENV) A-3
configuration, hardware 3-4
configuring
IndustryPacks A-14
MVME162LX board 2-1
VMEbus interface A-10
connections, serial cable 2-20
connectors on J17 (serial) 4-9
connectors, MVME162LX 1-27
console port 4-9
control bit, definition of 1-12
control module, network boot 3-21
controller and device parameters, 162Bug 3-19
controller LUN (CLUN) B-2, C-1
cooling requirements 1-9
count (command syntax) 4-3
creating a program 4-10
D
data bus structure 1-15
data terminal equipment (DTE) 1-21
date and time, setting 3-7
debug monitor 2-3
debug port 4-9
debugger
address parameter formats 4-6
command set 4-20
Configure Board Information Block (CNFG)
command A-1
overview 3-1
prompts 3-2, 4-1
Set Environment (ENV) command A-3
decimal numbers 1-11
default configuration, disk/tape controller B-2
device LUN (DLUN) B-2, C-1
device probe function, 162Bug 3-16
diagnostic facilities 3-25
direct access devices B-2, B-3
directories, switching 3-25
disk I/O
error codes 3-19
support 3-15
via 162Bug commands 3-16
via 162Bug system calls 3-17
disk/tape controller data B-1
DLUN (device LUN) B-2, C-1
documentation
non-Motorola single publications 1-5
other applicable Motorola publications 1-4
double precision real (floating point
format) 4-19
double-button reset 3-11, D-2
downloading S-record object files 4-10
DRAM (dynamic RAM)
options 1-16
base address 2-18
DTE (data terminal equipment) 1-21
E
ECC DRAM 2-13
EIA-232-D ports 3-5, 4-13
elevated-temperature operation 1-9
entering and debugging programs 4-9
entering debugger command lines 4-1
ENV command parameters A-4
EPROM (see 27C040 EPROM) 3-3
address ranges 2-10
and Flash memory 1-20
sockets 2-9
EPROM/Flash mapping 2-11
EPROM/Flash selection 2-12
error codes
disk I/O 3-19
network I/O 3-22
Ethernet
controllers C-1
driver 3-20
interface 1-22
station address 1-22
exception vectors, 162Bug 4-13
exponent field (floating point support) 4-18
expression (command syntax) 4-3
expressions as parameters 4-3
extended addressing mode 2-18

Table of Contents

Related product manuals