Motorola 700 Series - Page 151

Index
IN-1
Numerics
162Bug (MVME162Bug) firmware 2-3, 3-1, 4-1
command set 4-20
default controller and device
parameters 3-19
implementation 3-3
installation 3-3
stack space 3-14
static variable space 3-14
vector table and workspace 4-13
27C040 EPROM 3-3
53C710 SCSI controller 1-23
82596CA LAN coprocessor 1-22
A
Abort function 3-11
ABORT switch 1-13
address
formats 4-6, 4-7
in command syntax 4-3
range 1-27
ranges, EPROM 2-10
address/data configurations 2-18
addresses as command parameters 4-5
addressing disk/tape controllers B-1
addressing mode, extended 2-18
arguments, command line 4-3
arithmetic operators 4-3
ASCII string (command syntax) 4-3
ASICs used on board 1-2
MC2chip 2-10, 2-12
VMEchip2 1-20
assembler/disassembler, creating a program
with 4-10
assertion, definition of 1-12
autoboot function 3-7
autojumpering function 2-17
B
backplane jumpers 2-17
Backus-Naur syntax, debugger commands
and 4-3
base address, DRAM 2-18
base and top addresses 4-7
base identifier, numeric values and 4-4
battery 1-18
battery-backed-up RAM (BBRAM) and
clock 1-20, A-3
BBRAM (battery-backed-up RAM) and
clock 1-20
BG (Bus Grant) signal 2-17
BH (Bootstrap and Halt) command 3-17
binary numbers 1-11
block diagram 1-14
blocks versus sectors 3-15
BO (Bootstrap Operating system)
command 3-17
board configuration 2-1
board layout 2-2
boot functions
autoboot 3-7
network boot 3-10
ROMboot 3-9
BOOTP protocol module 3-21
Break function 3-12
BREAK key 3-12
Bus Grant (BG) signal 2-17
byte, definition of 1-12
C
C programming language 3-3
cable(s) 2-17
checksum, testing NVRAM contents with A-3
CLUN (controller LUN) B-2, C-1
command identifier, debugger 4-3
command lines, debugger 4-1
command syntax, debugger 4-3