passwords into each client device that you want to connect to your network.
Typically, you should enter SSIDs and Passwords for both the 2.4 and 5 GHz bands
into client devices that support both bands. If you haven’t changed the factory
settings, you can find these on a label on the bottom of your modem’s stand. If
you have changed the network names and/or passwords, use your new values.
(See Chapter 8 if you want to change your wireless settings).
If you want to connect devices to a Guest Network, use the Network Name and
Password for that network. (See Chapter 8 if you want to set up a Guest
Network).
Wireless devices vary, but they all have a Wireless Settings area. There you should
first select the wireless network you want, namely the wireless network name or
Guest network name of the MG7540. Now enter the password for your wireless
network. Make sure to turn wireless ON on your client devices. Normally that’s all
you need to do.
To Next Page
Loading...
