25
English
SCAN
SCAN
You can monitor multiple channels and receive
any calls that are transmitted on them. Sixteen
different channels can be programmed into
each scan list by your dealer. Your radio will
automatically switch to a scan list channel
when it detects activity on it.
Note: The same channels can be assigned to
different scan lists.
STARTING OR STOPPING SCAN
The LED indicator blinks green during a scan
operation and stops blinking when the radio
switches to a channel.
To start or stop a scan operation, press the
preprogrammed Scan button.
TALKBACK
If the Talkback option is preprogrammed, you
can respond to any calls received during the
scan operation. To respond, press the PTT
before the programmed hangtime elapses.
Otherwise, the radio will continue scanning.
Check with your dealer for details.
DELETING A NUISANCE CHANNEL
Note: Your dealer must have preprogrammed
a button to Nuisance Delete to access
this feature.
If a channel continually generates unwanted
calls or noise (a “nuisance” channel), you can
temporarily remove it from the scan list:
Note: You cannot delete a priority channel or
last remaining channel in the scan list.
Restoring a Channel to the Scan List
1 While the radio is on the Nuisance Channel,
press the preprogrammed Nuisance
Channel Delete button until you hear a tone.
2 Release the Nuisance Channel Delete
button. The nuisance channel is deleted.
1 Press the Scan button to stop the scan.
2 Press the Scan button again to start scanning
again. The Deleted Nuisance Channel is
restored to the scan list.
To Next Page
Loading...
