Motorola DSR-6402 - ASI Input; Input Field; Gige Input

DSR-6400 Series 31
ASI Input
Input Field
Use this section to specify the ASI input port. The Input field displays the active input. Press the
4
button until the cursor is at the Input label and press ENTER. Press the

buttons to scroll to ASI
In. Press ENTER to confirm the selection and return to the top line of the menu.
The following screen prompts the user to confirm the selection and exit the field.
If you press any arrow button (
4
) at this point, the Caution screen disappears and the
MANUAL TUNE menu reappears without any changes. To set the port selection, press ENTER.
Skip to page 38 to set the remaining installation fields.
GigE Input
Input Field
Use this section to specify the GigE input port. The Input field displays the active input. Press the
4
button until the cursor is at the Input label and press ENTER. Press the

buttons to scroll to GigE
In. Press ENTER to confirm the selection and return to the top line of the menu.
The following screen prompts the user to confirm the selection and exit the field.
If you press any arrow button (
4
) at this point, the Caution screen disappears and the
MANUAL TUNE menu reappears without any changes. To set the port selection, press ENTER.
E ASI In
MANUAL TUNE Input
Press E to continue or to stop
Service will be interrupted
E GigE In
MANUAL TUNE Input
Press E to continue or to stop
Service will be interrupted