Motorola EP450

36
English
SCAN
STOP SYSTEM SCAN
Press the preprogrammed Scan button to stop
System Scan (see page 22).
– or –
Note: Your dealer/programmer can prepro-
gram your radio when exiting System
Scan to automatically revert to the last
scan channel that had activity on it or
to automatically revert to the channel
where scan was initiated.
START AUTO SCAN G
Auto Scan automatically starts scanning once
a channel with Auto Scan enabled is selected.
Select a channel that has been
preprogrammed for Auto Scan by your dealer/
programmer.
STOP AUTO SCAN
Select a channel that has not been
preprogrammed for Auto Scan by your dealer/
programmer.
• The Gsymbol disappears from the
display.
The display shows the current scan status.
5 L or M until
6 J to select the current setting.
1 J to enter menu mode.
2 L or M until
3 J to select
The display shows the current scan status.
4 L or M until
5 J to select the current setting.
•The Gsymbol disappears from the
display.
SCAN ON
SYS SCAN
SYS SCAN
SCAN OFF