Additional Operations
17
Additional Operations
Display Backlight
• Press the Toggle Light / Enter Button (4) to turn on /
off the backlight.
NOTE
To conserve power, the backlight is programmed to
automatically turn off after 5 seconds.
NOTE
Pressing either the
Push-To-Talk (PTT) Button (6)
or the
Monitor Button (5)
has no effect on the back-
light.
PTT ID
If programmed, the radio transmits a DTMF identifica-
tion code (unit ID), indicating which portable is in oper-
ation.
During a conversation, the code is normally sent only
on the initial
Push-To-Talk (PTT) Button (6)
press
(unless PTT ID has been disabled). The ‘TX’ indicator
lights for the duration of the PTT ID. If there is no PTT
or receive activity for 7 seconds, or if you change the
channel (or scan resumes), the PTT ID is once again
transmitted on the next
Push-To-Talk (PTT) Button (6)
press.
• Press and hold to enable / disable PTT ID.
NOTE
Upon pressing , you will hear a beep. Hold the
button down until you hear a second beep, indicat-
ing that the PTT ID status has been changed.
When PTT ID is
disabled
, the ‘dot’ indicator flashes
on the display (To enable / disable PTT ID on non-
keypad radios, please contact your dealer).
#
To Next Page
Loading...
