Motorola GP-68 - Special Programming Mode (SPM); Entering SPM Mode; Exiting SPM Mode

Special Programming Mode (SPM)
29
Special Programming Mode (SPM)
The Special Programming mode (SPM) allows you to
edit all user-modifiable parameters within your radio,
such as the
Channel Scan list , Phone Access / Deac-
cess codes
, and Alert Tone Settings . Certain parame-
ters (such as the
Selective Call Tone Status ) are only
accessible with the installation of an option board.
Upon entry to the Special Programming mode, the
radio initiates the
SPM Browse menu which provides
you with a menu of available parameters and their cur-
rent settings.
Entering SPM
➊ Turn the radio off (if it is on).
➋ Turn the radio on while holding (or ) .
Keep holding this button until a SPM start-up tone
sounds.
NOTE
At power-up, all display segments light up for about
2 seconds. If successful, the
LCD Screen (18) dis-
plays .
NOTE
If the battery level is low, the display indicates
and the ‘BATT’ indicator flashes. The radio
also sounds a
Low Battery alert tone. Turn off the
radio and replace or recharge the battery.
Exiting SPM
• Turn off the radio to exit SPM.
ME
M