Motorola GP-68

Radio to Radio Cloning
41
Radio to Radio Cloning
Cloning duplicates the contents of one radio (the mas-
ter radio) into another (the slave radio). Only current
radio configuration, channels and phone numbers are
copied from one radio to another. Tuning and align-
ment information are not affected by cloning. You need
a cloning cable in order to perform this operation.
SCI
SCI stands for Serial Communications Interface. It is
used to configure the radio and for radio to radio clon-
ing.
To Clone a Radio
CAUTION
Make sure both master and slaves radios are
turned off.
➊
Lift the flap covering the SCI Port (17) of the mas-
ter radio.
➋
Insert the cloning cable jack into the SCI Port (17).
➌ Lift the flap covering the SCI Port (17) of the slave
radio.
➍
Insert the other end of the cloning cable jack into
the SCI Port (17)
of the slave radio.