Motorola GP-68

Radio to Radio Cloning
42
➎ Turn on the slave radio.
➏ Press and hold before turning on the master
radio.
NOTE
The master radio displays on the LCD
Screen (18)
if cloning can proceed, otherwise an
error message will be shown.
NOTE
The slave radio displays while it is being pro-
grammed. If battery level is low, the slave radio dis-
plays . You will need to replace the battery
before repeating the process.
NOTE
When cloning is completed, both radios will reset
automatically.
➐
Disconnect the radios from the cloning cable when
the process is completed.
Error Conditions
Error Message Problem Solution
Err.01
Incompatible software
options error.
Cloning from the master radio to the
slave radio cannot be performed.
Err.02
Timeout error
a. The cloning cable con-
nection is not properly
connected or slave
radio is not turned on.
b. Communication
between the two radios
is disrupted during the
cloning process.
a. Check the cloning cable connection and
also verify that the slave radio is turned
on.
b. Check the cloning connection and all
other connections.
Err.03
Master radio
checksum error
Although the master radio may still
function, it should be serviced by a
dealer.
Err.04
No Programmed Chan-
nels Error
a. If this occurs on the slave radio, repeat
cloning procedure. If it persists, the
radio must be serviced by a dealer.
b. If this occurs on the master radio, the
radio must be serviced by a dealer.
A
SIG