DTMF Telephone Interconnect
25
Storing a Phone Number
A maximum of 9 telephone numbers (up to 12 digits
each) can be stored into the radio memory. Each
phone number is stored and recalled via a unique
number on the keypad in the range of 1 to 9. The fol-
lowing procedure can also be used to store the access
/ deaccess codes (up to 8 digits each):
➊
Press and hold until you hear a second Valid
Button Press tone (takes about 2 seconds).
➋
Enter a phone number location (in the range of 1 to
9) to store a phone number or press to store
the access code or to store the deacess code.
➌
Enter the phone number (up to 12 digits long), or
access / deaccess code (up to 8 digits long).
NOTE
Valid digits are DTMF digits 0 to 9, the characters
A, B, C, D, ∗ and #, and pause digits.
NOTE
Pause digit ( )causes the radio to wait in
between transmission of the digits programmed
before and after it. One or more pause digits can be
entered between successive digits of the phone
number (or access / deaccess code). When a
pause digit is successfully entered, two beeps are
heard; the display changes from ‘A’ to ‘-’. Pause
digits placed at the end of a phone number are not
remembered by the radio.
ME
To Next Page
Loading...
