Special Programming Mode (SPM)
31
Editing SPM Parameters
Editing the Channel Scan List
➊
In SPM, rotate the Channel Selector Knob (2) to
select the Edit Channel Scan List ( ) menu
item.
➋
Use or
(or )
to scroll through the
channels (01 to 20).
NOTE
The channel scan list does not wrap around to the
opposite end of the list. Instead, an
Invalid Button
Press
tone sounds when you have reached the
upper or lower limit of the list.
NOTE
A flashing channel number indicates that the chan-
nel is excluded from the scan list.
➌
Press the Toggle Light / Enter Button (4) to toggle
the status of a channel i.e. being included or
excluded from the scan list.
NOTE
A
Valid Button Press
tone sounds when the new
setting is stored.
➍
To exit this menu, select another menu item by
turning the Channel Selector Knob (2).
Editing the Phone Access / Deaccess Codes
➊
In SPM, rotate the Channel Selector Knob (2) to
the Edit Phone Access (
)
or Edit Phone
Deaccess
( ) menu.
➋
Press or to enter the edit mode.
ME
To Next Page
Loading...
