Special Programming Mode (SPM)
33
the edit mode time-out (after 5 seconds of inactiv-
ity).
Editing the Time-Out Timer Duration
➊
In SPM, rotate the Channel Selector Knob (2) to
the Edit Time Out Timer (
xxx) menu.
NOTE
xxx represents one of , , , ....., . The
default display of shows the time-out timer
setting of one minute. If the display shows ,
this indicates that the time-out timer is disabled.
This means that there is no limit on the transmit
time.
➋
Use or
(or )
to change the current
status.
CAUTION
The new setting is stored immediately.
➌
To exit this menu, select another menu item by
turning the Channel Selector Knob (2).
Setting the Selective Call Tone Status
Selective Call alert tones give an audible indication of
receipt of a
Voice Selective Call
(
SelCall
). If disabled,
the alert tones do not sound when
Voice Selective Call
messages are received by the radio.
ME
To Next Page
Loading...
