4-8 Programming Mode
PRMT-XXX Prime Channel
Return Hang
Time
PRMT-OFF,
PRMT-001,
...,
PRMT-015
PRMT-007 ¥ This feature is only valid if a Prime Channel is pro-
grammed.
¥ XXX denotes the time that the radio will stay idle in
a non-Prime channel before switching back to the
Prime channel.
¥ Select OFF if you do not wish to switch to the Prime
channel automatically.
¥ Unit is in seconds. Prime Channel Return Hang
Time is therefore programmable from 1 second to 15
seconds in increments of 1 second.
PID-XXXX PTT ID Trans-
mit Manner
PID-OFF,
PID-PRE,
PID-POST,
PID-BOTH
PID-PRE ¥ Select how the PTT ID is transmitted: OFF (not
transmitted), PRE (transmitted upon PTT press),
POST (transmitted after PTT is released), BOTH
(transmitted upon PTT press as well as after PTT is
released).
¥ Press + or - to select the desired PTT ID transmit
manner.
NOTE: PTT ID has to be enabled on a per channel
basis to enable transmission.
ST-XXX PTT ID
Sidetone
ST-OFF,
ST-ON
ST-ON ¥ When PTT ID Sidetone is enabled (ON), an alert
tone is heard as soon as PTT is pressed, and when
PTT ID is being sent.
¥ Press + or - to select ON or OFF.
SST-XXX PTT ID Short
Sidetone
SST-OFF,
SST-ON
SST-OFF ¥ When PTT ID short sidetone is enabled (ON), an
alert tone is heard after PTT ID is sent. It indicates
that the user is ready to start talking.
¥ Press + or - to select ON or OFF.
PTM-XXXX Tx Pretime PTM-0000,
PTM-0025,
É.,
PTM-4000
PTM-0050 ¥ Pretime is the duration from which PTT is pressed
to the time when PTT ID is ready to be sent.
¥ Adjust the pretime to suit the repeaterÕs response
time.
¥ Unit is in ms. Pretime is therefore programmable
from 0 ms to 4000 ms in 25 ms steps.
¥ Press + or - to select the desired pretime.
LGT-XXXX Backlight
Select
LGT-AUTO,
LGT-TOGL
LGT-AUTO ¥ Selecting LGT-TOGL causes the Backlight button
to toggle the ON/OFF status of the LCD backlight.
¥ Selecting LGT-AUTO causes the backlight to be
turned off, if there is no keypress for more than 5
seconds.
¥ Press + or - to select the desired backlight setting.
PTT-ID PTT ID 8 charac-
ters consist
of 1,2, É, 9,
0, A, B, C,
D, *, # and
Pause.
Blank ¥ PTT ID is sent when PTT is pressed. It serves as
the identity of your radio.
¥ Press + or - to move the cursor to the appropriate
character. Use the keypad to enter the ID. Pause can
be entered by pressing * followed by #. Enter # 8
times to erase ID.
¥ Refer to "4.10.4 Programming an ID" on page 21
for details.
RW
Parameter
Description Range
Default
from
Factory
Remarks
To Next Page
Loading...
Need help?
General
