37
CONVENTIONAL
FEATURES
English
CONVENTIONAL FEATURES
This section outlines the conventional features of your
radio. All references to what is shown on the display is
only valid for GP280 radios. Throughout this section,
the display below
is used to indicate the radio’s home display.
REPEAT/DIRECT
The repeat/direct feature allows you to bypass the
repeater and talk directly to another portable radio.
This is known as DIRECT operation. The transmit
frequency is the same as the receive frequency.
• In REPEAT operation, you talk through the
repeater, which increases the radio's operating
range. The transmit frequency is not the same
as the receive frequency.
• If the repeat/direct feature is programmed to a
mode, that mode operates on either direct or
repeat operation.
• If the repeat/direct feature is programmed to the
keypad, you can change the repeat/direct setting
by doing the following.
SMART PTT
Smart PTT is a per-mode feature which gives the
system manager better control of radio operators.
When smart PTT is enabled in your radio, you cannot
transmit on an active mode. Three radio-wide
variations of smart PTT are available.
• Transmit Inhibit on Busy Mode—you are
prevented from transmitting if any activity is
detected on the mode.
1. Press / until DIR is
displayed.
PLANT POLICE
DIR
PWR PROG
2. Press l (the softkey below DIR).
3. The current talkaround
state appears on the
display for a few
seconds.
or
4. Then, the display
prompts for the new
state.
5. Press l below the desired talkaround
state: repeat (RPTR) or direct (DIR).
6. The radio returns to the
home display.
REPEATER MODE
DIRECT MODE
DIR
RPTR
PLANT POLICE
UG_240_280_EN.fm Page 37 Wednesday, August 14, 2002 10:30 AM
To Next Page
Loading...
Need help?
General