BASIC LEVEL TEST MODES AND PROCEDURES: Test Modes
68P80401P05 35
N6:1 Intrcnct Parameter details for the 6:1 Interconnect Feature enabling transmission of RF-originated
messages through the telephone system.
Line 1 shows MS, the Mobile Subscriber's ability to support 6:1 Interconnect and FNE, the
Fixed Network Equipment’s ability to support 6:1 Interconnect respectively. Numbers 0 or
1 indicate No or Yes respectively.
Line 2 shows I, Interleave of the current channel, O, Offset of the current channel, and S,
Sub-slot of the current channel. Values for Interleave are 1 – 24, Offset values are 0 – 23,
and Sub-slot can be A, B or N.
Line 3 shows ECC, Extended Color Code and PO, Primary Control Channel Offset of the
current carrier.
Values for ECC are 0 – 16. Values for PCCH Offset are 0 - 11.
During Trace Mode, radio activity such as interconnect, dispatch call, packet data session,
registration, or location update information will automatically update every 2 seconds.
N6:1 Dispatch Displays status of a new 6:1 dispatch call. Data displayed shows “MS 1 FNE 1”. All other
data combinations are old 6:1 dispatches.
GPS Displays the GPS location, time info, assist, navigation, summary, GPS version.
IMEI/SIM ID/SN Displays the electronic serial number, SIM ID serial number, and unit serial number.
The IMEI is the global name assigned to the mobile station at manufacturing time and
should correspond to the serial-number tag of the unit.
The SIM ID is the SIM electronic serial number and should correspond with the number
stamped on the SIM card. The SN is applied during manufacturing.
Pressing OK allows the IMEI/SIM ID to be traced.
Registration Log Displays the Dispatch Log, Interconnect Log, Packet Data Log, Mobile IP Log, and Phone
Rst Log. Registration Log information is updated when the user deselects and selects the
Registration Log choice.
Err/Channel Displays the physical channel that the unit is connected to or the radio link procedure that
is currently active. Also, displays error codes encountered during normal operation if Err/
Channel is On. At power up, Err/Channel is Off.
Current Freq Displays current frequency and band. Pressing OK allows the current frequency and band
to be traced.
Dispatch IDs Displays the Dispatch Group ID affiliated with the unit in the current dispatch-location area.
Also, displays the Dispatch Individual ID affiliated with the unit in the current dispatch
location. Pressing OK allows the dispatch IDs to be displayed periodically.
Band Info Displays primary and secondary bands.
Bandmap Displays the currently selected regional bandmap. Pressing OK allows the bandmap to be
displayed periodically.
Hardware Displays the AFC Offset and Channel Number.
Pressing OK allows the hardware parameters to be traced.
Fatal Err/# Displays the Fatal Error log. This log contains a count of any fatal errors logged during the
unit's automatic self test. Optioning clear empties the log.
Flags: Displays the error log. This log contains any errors logged by the unit software. Pressing
Menu when it appears displays the Clearall screen in which the user can clear all the logged
errors.
Table 6-1. Display Screens (Continued)
Name Description
To Next Page
Loading...
